Installing The Evaporator Unit - Dometic COOLAIR SP950I Instructions De Montage

CoolAir SP950I
I
NOTE
The fastening screws M6 x 40 mm included are designed for use with the
spacer sleeves, l = 25 mm, (e.g. MAN TGX).
The fastening screws M6 x 110 mm included are designed for use with the
spacer sleeves, l = 40 mm, (e.g. Volvo FH as of construction year 2013) (two
spacer sleeves for each screw).
By combining the spacer sleeves, different distances between the rear wall of
the cab and inner trim can be achieved.
The screw overhang beyond the nut must not exceed 15 mm.
If spacer sleeves are not to be used or if other ones are to be used, the fastening
screws have to then be adapted to match them. Otherwise the unit housing
may be damaged.
6.4

Installing the evaporator unit

The evaporator unit is fitted on the cab's rear panel, near the bunk, in a horizontal
position:
➤ Remove the panelling from the evaporator unit (fig. 5, page 4).
➤ Pull the housing back slightly and detach the connecting plug from the
control panel's connection cable (fig. 6, page 5).
➤ Find a suitable fastening position in the cab that allows sufficient air
circulation.
A
NOTICE!
• Make sure that the drill template included is not upside down when
positioned!
• You can position the drill template from the inside or from the outside onto
the cab. Make sure that the following holes are used for the connecting and
condensation line:
– from inside: holes that bear the inscription "Inside"
– from outside: holes that bear the inscription "Outside"
➤ Use the drill template included to determine the position of the evaporator
unit. Position the template at the selected point and use a felt pen to mark the
positions of the four holes (Ø 6.5 mm) for fastening.
➤ Mark the positions of the holes for feeding through the connection line
(Ø 48 mm) and the condensation line (Ø 15 mm).
EN
Installation
19