Installing The Receiver - Dometic FreshWell3000 Instructions De Montage

Installation
7.6

Installing the receiver

See fig. 9
➤ Drill an opening of 50 mm into the wall.
See fig. 0
➤ Lay the cable through the hole to the under-bench air conditioner.
➤ Fasten the receiver as shown.
7.7 Laying the connecting cables
D
DANGER! Danger of electrocution
Make sure there is no voltage at electrically operated components
before carrying out work on them!
The under-bench air conditioner must be connected to an electric circuit which is
able to supply the required current (see chapter "Technical data" on page 15).
➤ Select the cross-section of the cable corresponding to the length:
– Length < 7.5 m: 1.5 mm²
– Length > 7.5 m: 2.5 mm²
See fig. a
➤ Plug the four-pole plug of the receiver into the IR socket of the (1).
➤ Plug the 230 Vw plug into an 230 Vw socket (2).
10
FreshWell3000
EN