Installing The Evaporator Unit - Dometic SPX1200I Instructions De Montage

Installation
6.4

Installing the evaporator unit

The evaporator unit is fitted horizontally on the cab's rear panel, near the bunk.
➤ Find a suitable fastening position in the cab that allows sufficient air
circulation.
A
NOTICE!
• Make sure that the drill template included is not upside down when
positioned.
• You can position the drill template from the inside or from the outside onto
the cab. Make sure that the following holes are used for the connecting and
condensation line:
– from inside: holes that bear the inscription "Inside"
– from outside: holes that bear the inscription "Outside"
➤ Drill the holes for mounting the evaporator unit (fig. 5).
I
NOTE
If the space between the interior trim and the cab's rear panel is large, the hole
(Ø 15 mm) for the inclined condensation line must be drilled slightly lower than
specified on the template. For a distance for the interior trim to the cab's rear
panel of approx. 25 mm the hole (Ø 15 mm) should be drilled approx. 5 mm
lower to ensure that the condensation drainage process functions.
➤ Drill the hole for the connection line (Ø 30 mm) (fig. 6).
➤ Drill the hole for the condensation line (Ø 13 mm) (fig. 6).
A
NOTICE!
Make sure that the coupling half with the thin, capillary tube is not twisted or
kinked.
➤ Carefully unwind the connection line.
➤ Fit the evaporator unit (fig. 7).
➤ Fasten the evaporator unit from the outside (fig. 8).
10
CoolAir SPX1200I
EN