Instructions before installation
6
Instructions before installation
➤ Before installation, check the roof thickness of your vehicle. Consult the vehicle
manufacturer if you have any questions.
➤ When choosing the installation location, observe the following:
– Adjoining components (roof rack or attachment and reinforcing parts), cables
and cabinets in the vehicle interior must not be damaged when sawing the
hole.
– Only fit the roof light on flat and parallel interior and exterior roof areas with a
maximum inclination of 15° to the horizontal.
– You may use an existing roof hole provided the roof light fits into it.
6.1
Pressing out the hole
See fig. 2
6.2
Using the reinforcing rails
Supplementary to fig. 3
➤ Before installation, check whether the roof hole needs reinforcing.
➤ Remove the foam according to the width of your reinforcing rail (not in scope of
delivery) (A).
➤ Fit the reinforcing rails (B).
7
Installing the Mini Heki S
Supplementary to fig. 4
The scope of delivery contains a mounting frame, which is suitable for roof thick-
nesses of 23 – 42 mm or 43 – 60 mm:
•
Roof thicknesses 23 – 42 mm: Item no. 9104100289
•
Roof thicknesses 43 – 60 mm: Item no. 9104100290
➤ Measure your roof thickness W.
➤ Shorten the sleeves to size H (see table).
➤ Use the screws with appropriate lengths (see table).
6
Mini Heki S
EN