Setting Up; Check Contents Of Pack; Connecting The Base Station; Fitting Standard Batteries - switel BDT700 Mode D'emploi

Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

3

Setting up

3.1
Safety information
NOTE: Before setting up, it is essential that you read the Safety Information at the
beginning of this operating manual.
3.2

Check contents of pack

The following items are supplied:
one base station
one handset
one telephone connecting cable
3.3

Connecting the base station

Position the telephone near to your telephone connection socket and to a mains socket.
1.
Insert the plug of the power supply into the socket on the backside of the base station
and plug the power supply into a properly installed 230 V mains socket. The plug-in
power supply for the base station must always be connected. For safety reasons, use
only the plug-in mains power supply provided.
2.
Connect the telephone cable supplied to the telephone socket and the telephone jack
on the backside of the base station. Use only the new telephone cable provided.
3.4

Fitting standard batteries

To fit the standard rechargeable batteries supplied into the handset,
press on the upper edge of the battery compartment and slide it
downwards. Now insert the batteries taking care to ensure that the
polarity is correct. Close the battery compartment cover.
Important note: Place the handset in the base station with the display to the
front for at least 16 hours. The telephone may malfunction if the batteries are not
properly charged. The charging light
104
- Setting up -
one mains cable
two standard batteries
one instruction manual
on the base station will come on.
+

Publicité

Table des Matières
loading

Table des Matières