Setting Up; Safety Information; Check Contents Of Pack; Connecting The Base Station - switel D7210 Mode D'emploi

3

Setting up

3.1

Safety Information

NOTE Before setting-up, it is essential that you read the General Information at the
beginning of this manual.
3.2

Check contents of pack

The following items are supplied:
one base station
one handset with belt clip
one telephone connecting cable
3.3

Connecting the base station

Position the base station near to your telephone connection socket and to a mains
socket. Your telephone works using Touch-Tone Dialling.
1. Insert the plug of the power supply into the socket on the underside of the base
station and plug the power supply into a properly installed 230 V mains socket.
2. Connect the telephone cable supplied to the telephone socket and the telephone
jack on the underside of the base station.
3. Run the two cables through the cable channels under the base station foot support
to the rear of the base station.
Note: The two plugs must audibly click
into place so that they do not fall out
again.
118
- Setting up -
one mains power supply
two standard batteries
one instruction manual