Operation; Switching On The Hob And Setting The Power - Pelgrim IDK785ONY Mode D'emploi

OPERATION

Settings

Switching on the hob and setting the power

The power has 9 settings. There is also a 'boost' setting, which is
indicated by a 'P.' in the display (see 'Boost').
1. Put a pan on a cooking zone.
2. Touch the On/Off button. You will hear a short bleep and the
display for each cooking zone will show '0.'. The red light to the
right above the On/Off button is constantly illuminated. If no further
action is taken, the cooking zone will automatically switch off after
10 seconds.
3. Use the button + or the - button in the desired cooking zone to
choose the correct setting. The hob will automatically start in the
chosen setting (if it detects a pan).
4. Touching the + button for the first time displays setting '4.'.
5. Touching the - button for the first time displays setting '9.'.
Tip
You can touch and hold the - or the + button to set the desired power
faster.
• Pan detection; If the hob does not detect a (ferrous) pan after the
cooking power has been set, the pan detection symbol and the
selected power setting will flash alternately on the display and the
hob will remain cold. If a (ferrous) pan is not placed on the cooking
zone within 1 minute, the cooking zone will automatically switch off
(see 'Pans').
• Residual warmth indicator; A cooking zone that has been used
intensively will retain heat for several minutes after it has been
switched off. An 'H.' appears in the display as long as the cooking
zone is hot.
Automatic heat-up function
The automatic heat-up function temporarily increases the power
(setting '9.') to heat the contents of the pan faster. This function is
available in all settings except the 'Boost' setting and setting '9.'.
EN 7