Switching On; Checking The Chain Brake - Grizzly EKS 2440 QT Traduction De La Notice D'utilisation Originale

GB
You should install time-delay fuses
with the designation "L", which can
be bought in every hardware store.
Fuses with the designation "G" are
provided with even longer time de-
lay, however they are not usually
employed in households.
Caution! Saw can oil up, see notes
on Operation startup.

Switching on

1. Check before the start, whether
D
sufficient chain oil is in the tank
and, if necessary, refill with
chain oil (see Chapter Operation
Start).
2. Form a loop from the end of the
extension cable and hang this
into the tension relief (17) on the
rear grip (1).
3. Connect the device to the mains
voltage.
4. Release the chain brake, where
you shift the brake arm (3) back
against the front grip (8).
5. Hold the electric chainsaw firmly
with both hands, with the right
hand on the rear grip (1) and the
left hand on the front handle (8).
Thumb and finger must close
securely over the handles.
6. For switching on, activate the
switch-on block (11) with the
right thumb and then press the
On/Off switch (10), the electric
power saw runs with highest
speed. Release the switch-on
block again.
7. The power saw switches off
when you release the On/Off
170
switch (10) again. Switching for
continuous running is not pos-
sible.

Checking the chain brake

The motor cannot be turned on
if the chain brake has engaged.
Do not employ the chain brake in
order to start the chainsaw or to
switch it off.
1. Place the electric chainsaw onto
E
a solid, flat surface. It must not
contact any objects.
2. Connect the device to the mains
voltage.
3. Release the chain brake by
shifting the brake arm (3) over
against the front grip (8).
4. Hold the electric chainsaw firmly
with both hands, with the right
hand on the rear handle
and the left hand on the front
handle (8). Thumb and finger
must close securely over the
handles.
5. Turn on the electric chainsaw.
6. Activate the chain braking lever
(3), with running motor, with the
left hand. Chain should stop
abruptly.
7. Once the chain brake is work-
ing properly, release the on/off
switch (10) and the chain brake.
If the chain brake does not func-
tion correctly, you must not use
the electric chainsaw. A slack
saw chain leads to danger of in-
jury. Return the electric chainsaw
to our Service-Center for repair.
( 1)
A