Stiebel Eltron SunWarmth CIR 150-1 I Mode D'emploi page 12

INSTALLATION
INSTALLATION
9 Remove end plate from heater: 6 Phillips screws fasten the
heater body end plate in place:
10 Slide cover plates and heater mounting bracket out from top
side of heater. Remove remaining end plate from other end
of heater:
11 Slide face plate out from each end of heater:
12 |SUNWARMTH ™ CIR INFRARED HEATER
12 Remove the heat lamp retainer clip at each end of lamp:
13 The heat lamp is fragile! Carefully side old heat lamp out of
heater through rectangular slot in end of refl ector:
Carefully install new heat lamp and clip in place.
»
Reverse steps above to reassemble the heater.
»
9.7.3 Heat lamp replacement - CIR 400-2 O
1 Compress the width of the protective grill to retract the wire
tabs from under one edge of the heater body.
Rotate the loose edge of the grill up and away from heater body.
»
Pull the grill away from heater to remove from other edge of
»
heater body - place safety grill in a secure storage container.
Repeat grill removal for other lamp if required:
»
2 Remove end plate from heater: 6 Phillips screws fasten the
heater body end plate in place:
WWW.STIEBEL-ELTRON-USA.COM