Stiebel Eltron SunWarmth CIR 150-1 I Mode D'emploi page 11

INSTALLATION
INSTALLATION
2 Remove connection box end cover. Six (6) Phillips screws
hold the end cover in place. Remove the screws and keep in a
secure storage area:
3 Remove connection box end cover. Six (6) Phillips screws
hold the end cover in place. Remove the screws to secure
storage:
4 Remove 2 Phillips screws that fasten the connection box face
plate in place:
WWW.STIEBEL-ELTRON-USA.COM
5 Disconnect electrical supply cord spade connectors from
terminals:
6 Loosen 2 screws in terminal block that connect the red heat
lamp wires in place. Remove ends of red wires from terminal
block.
Loosen plastic collar on Liquid Tight Connector that secures
red wires to connection box:
7 Slide power cord retainer plate from heater body (top surface
of heater):
8 Loosen plastic collar on second Liquid Tight Connector that
secures red wires through connection box end plate.
Slide red wires out of connection box.
»
Set connection box aside:
»
SUNWARMTH ™ CIR INFRARED HEATER| 11