Stiebel Eltron SunWarmth CIR 150-1 I Mode D'emploi page 13

INSTALLATION
INSTALLATION
3 Remove 4 Phillips screws that hold connection box to heater:
4 Remove the 2 Phillips screws that fasten the electrical
connection box front face plate in place:
5 Slide the connection box front face plate out from the
electrical connection box:
6 Slide power cord retainer plate from electrical connection
box (top surface):
WWW.STIEBEL-ELTRON-USA.COM
7 Loosen screws in terminal block to remove wires as required:
RED wires connect to Lamp #1 (closer to connection box)
»
BLUE wires connect to Lamp #2 (further end from box)
»
Do not disconnect power supply wires
»
Loosen the threaded clamping collar on the Liquid Tight
»
Connector located behind the wiring terminal
Pull wires out through the Liquid Tight Connector and top of
»
electrical connection box:
8 Slide lamp wires out of electrical connection box. Set
electrical connection box aside:
9 Remove interior end plate from heater: 6 Phillips screws
fasten the heater body end plate in place:
SUNWARMTH ™ CIR INFRARED HEATER| 13