Stiebel Eltron SunWarmth CIR 150-1 I Mode D'emploi page 10

INSTALLATION
INSTALLATION
5 Disconnect electrical supply cord spade connectors from
terminals:
6 Disconnect ground wire (electrical supply cord) from the
heater body by removing the anchor screw from the eye of
the ground terminal:
7 Slide power cord retainer plate from heater body:
10 |SUNWARMTH ™ CIR INFRARED HEATER
8 Turn heater face up. Each end of the lamp has a rectangular
retainer block. Remove the stainless steel clips that secure
the retainer blocks at each end of the lamp:
9 Pull the lamp wires up and out from the heater body at each
end of the lamp:
10 Slide the lamp out through the refl ector end plate. Properly
and safely dispose of lamp:
11 The heat lamp is fragile - handle with care! Wear gloves. Do
not touch lamp with bare fi ngers! Oils from your skin will
damage the lamp.
Install the new replacement lamp
»
Reassemble heater in reverse order of steps above.
»
9.7.2 Heat lamp replacement - CIR 150-1 O and CIR 200-2 O
1 Compress the width of the protective grill to retract the wire
tabs from under one edge of the heater body.
Rotate the lose edge of the grill up and away from
»
heater body.
Pull the grill away from heater to remove from other edge
»
of heater body - place safety grill in a secure storage
container:
WWW.STIEBEL-ELTRON-USA.COM