Installation Accessory; Installation Method - mundoclima MUCR-12-H8 Manuel D'installation Et L'utilisauter

WIRED CONTROLLER

2. Installation accessory

2.1 Select the installation location
Don't install at the place where cover with heavy oil, vapor or sulfureted gas,
otherwise, this product would be deformed that would lead to system malfunction.
2.2 Preparation before installation
1. Please confirm that all the following parts you have been supply.
No. Name
1
Wire controller
2
Installation and owner's manual
3
Screws
4 Wall plugs
5
Screws
6 Plastic screw bars
7
Battery
8
The connective wires group
2. Please filed install the following accessory.
No.
Name
1
Switch box
Wiring Tube(Insulating
2
Sleeve and Tightening
Screw)
Precaution of install the wire controller
1. This manual provides the installation method of wire controller. Please refer to the
wiring diagram of this installation manual to wire the wire controller with indoor unit.
2. The wire controller working in low voltage loop circuit. Forbid to directly contact the
cable of 220Vcommercial electricity or of 380V high voltage, and don't wire this kind
of wire in the said loop; wiring clearance between configured tubes should at the
range of 300~500 or above.
3. The Shielded wire of the wire controller must be grounded reliable.
4. Upon finish the wire controller connection, do not employed tramegger to detect the
insulation.

3. Installation method

1. Dimensions
Qty.
1
1
3 M4X20 (For Mounting on the Wall)
For Mounting on the Wall
3
2
M4X25 (For Mounting on switch box)
For fixing on switch box
2
1
1
Connective wire 6 m.
Qty.(embeded
(only for reference)
into wall)
1
1
120
18.5
Fig 3-1
Remarks
Specification
Remarks
46
62
90