Important; Lateral And Bennett Movement - Ivoclar Vivadent Stratos 300 Mode D'emploi

5.2.2 PR stop (9.2) for centric shift
The PR stop permits each condyle to be incrementally advanced
from 0 to 4 mm into a protrusive position.
9.2
9.1
Loosen the screw for the PR stop (9.1) and move the PR stop (9.2)
into the desired position on the PR scale (9.0). By fastening the
screw for the PR stop (9.1), the position can be fixed.

Important:

In this case, the centric fixation cannot be used.
12
9.0
5.3

Lateral and Bennett movement

5.3.1 Lateral and Bennett movements
The lateral movements can be simulated when the centric fixation
(4.1) is open, according to the schematic below. To perform this
movement, press with your thumb unilaterally on the joint of the
corresponding side.
Bennett angle
By loosening the B knurled screw (3.2), the Bennett angle can be
read off, adjusted and fixed with the Bennett angle scale (3.3).
3.2