Receiver Antenna - ProBoat UL 19 Manuel De L'utilisateur

SPMSR315 Dual Protocol Receiver
Specifi cations
Type: Dual Protocol 3 Ch Receiver* (SLT/DSMR)
Dimensions (LxWxH): 32.5 x 21.5 x 12.4mm
Antenna Length: 90mm
Channels: 3
Weight: 6g
Band: 2.4GHz
Voltage Range: 3.5–9.6V
Bind Type: Bind Button
Failsafe: Hold the steering wheel and throttle trigger in the desired failsafe positions
during binding
*SPMSR315 receivers included with the SLT3 transmitter include SLT and DSMR
compatibility. If you have an SR315 receiver that was purchased by itself, you may need to
install a firmware update to make your SR315 SLT compatible.

Receiver Antenna

The SR315 receivers feature a coaxial antenna design for easy installation in almost any model. Think of the last 1
inch (32mm) on the tip of the antenna as the active portion of the antenna, the coaxial portion leading up to it is just
an extension. Install the antenna so the active portion is positioned as high as possible in the vehicle, and not "in the
shadow" of any carbon fiber or metal. The case of the receiver can accept an antenna tube directly, making optimal
antenna placement easy (antenna tube not included).
WARNING: Do not kink, cut or damage the antenna wire. The antenna is made of a coaxial wire; if the outer
sheath becomes damaged, the receiver will not work properly. If the antenna is damaged in any
way, replace the antenna before attempting to use the receiver.
Binding
Binding is the process of programming the receiver to
recognize the GUID (Globally Unique Identifier) code of
a single specific transmitter.
1. Press and hold the bind button, and Power ON the
receiver; the orange LED will begin to flash.
2. Set the trims and control positions at the desired
failsafe settings, and power ON the SLT3 transmitter.
3. When the orange LED on the SLT3 transmitter
remains lit, it is connected to SR315 receiver.
You must rebind when:
• Different failsafe positions are desired e.g., when
throttle or steering reversing has been changed.
Binding the receiver to a different transmitter.
30 - INCH READY - TO - RUN BRUSHLESS BOAT
Failsafe
In the unlikely event that the radio connection is lost
during use, the receiver will drive the servos to their pre-
programmed failsafe positions as set during Binding.
If the receiver is powered on before powering on the
transmitter, the receiver will enter this failsafe mode.
When the transmitter is powered on, normal control is
resumed.
IMPORTANT: Failsafe activates only in the event
that signal is lost from the transmitter. Failsafe will
NOT activate in the event that receiver battery power
decreases below the recommended minimums or
power to the receiver is lost.
Bind Button
EN
BATT
STR THR AUX 1
7