SEVERIN JG 3521 Mode D'emploi page 16

P 1-5
∙ The pre-set or last selected preparation
time flashes on the display.
∙ If needed, turn the Easy-select control to
change the processing time.
∙ Press the Easy-select control briefly.
The programme starts.
P 6
∙ The temperature last selected flashes
on the display.
∙ Turn the Easy-select control and select
the temperature (35-45 °C).
∙ Press the Easy-select control briefly.
∙ The indicator P6 flashes briefly on the
display, followed by the processing time
last selected.
∙ Turn the Easy-select control and select
the processing time (1-24 h).
∙ Press the Easy-select control briefly.
The programme starts.
∙ The light-ring turns blue and the display
shows the remaining running time.
∙ During processing, the remaining time
can be changed at any point by turning
the Easy-select control. The total
runtime set in this way is saved in the
programme for future applications.
∙ The yoghurt maker should then be left
undisturbed until the yoghurt has set.
Avoid cold draught, shocks and
movement.
∙ The yoghurt will be ready once the
required processing time has elapsed.
∙ The light-ring goes out. The appliance is
in stand-by mode.
∙ Remove the plug from the wall socket.
∙ Transfer the warm jars to the refrigerator
and allow the yoghurt to develop further
16
for a while.
∙ If you wish to make fruit yoghurt, add
the fruit to the warm yoghurt before you
transfer the jars to the refrigerator to
cool.
∙ Once you have made your first batch of
yoghurt, reserve the required amount of
the yoghurt for your next batch.
∙ Remark: After several cycles the
yoghurt may become watery, and it is
then time to restart the process with
fresh natural yoghurt or fresh yoghurt
powder.
Interrupting a programme
∙ To interrupt an active programme
or programming procedure, press
the Easy-select control for around 2
seconds. The appliance goes into stand-
by mode.
Switching off
∙ With the appliance to stand-by mode, a
longer press sets the appliance to sleep
mode.
Automatic switch-off
∙ If no input is registered for 30 seconds
during programming, the appliance
changes into stand-by mode.
∙ After 5 minutes in stand-by mode, the
appliance automatically changes to
sleep mode.
∙ Turning or briefly pressing the Easy-
select control re-activates the appliance.
The programme last used is shown in
the display.