Making Preparations - Mesto PRIMER 3237P Mode D'emploi

GB IRL

Making preparations

Observe the instructions in the section entitled „Safety".
The device must be in an upright position.
into the tank.
1. Pull up the red button on the piston pressure gauge [10] until all excess pressure is
released from the tank
2. Press the piston rod with handle [11] down and turn it counterclockwise
3. Unscrew the pump [2] from the tank.
4. Add the spraying liquid to the tank [1]
6. Screw the pump [2] into the tank.
7. Press the piston rod with handle [11] down and turn it counterclockwise.
8. Generate the desired pressure
9. Press the piston rod with handle [11] down and turn it counterclockwise
Spaying
Observe the instructions in the section entitled „Safety".
Operate the device only while it is vertical or suspended upright and nearly
vertical.
Avoid allowing drops of spray to drift onto areas that are not being treated.
Observe the instructions of the spray product manufacturer!
1. Hang the device over your shoulder.
2. Activate the shut-off valve [4]
gauge [10]
Spraying pressure
1.5 bar
2.0 bar
3.0 bar
Table 2. Linear dependence: spraying rate and spraying pressure
4. If the spraying pressure decreases more than 0.5 bar from the optimum level, pump
some more.
AUS
.
USA NZ
in the tank
0.56 l/min
0.64 l/min
0.78 l/min
16
CDN IND
.