Safety Features; Cleaning And Maintenance; Ce-Statement - EUROM EK2001 Manuel D'utilisation

If the heater is being used for the first time (or if you want to reset the desired temperature), turn the thermostat
dial to the maximum position (clockwise as far as it goes).
With the mode selector dial, adjust the heater to suit your preferences.
Once the temperature in the area being heated has reached the right level, slowly turn the thermostat dial
anticlockwise until you hear a soft click; leave the dial in that position. The heater will automatically maintain the
temperature at this level. It does this by switching the heating elements off and on when the temperature rises or
falls too much.
Note! After the thermostat has switched the heating elements off, the fan will keep turning. This means that the air
is constantly moved, allowing the heater to accurately detect if the area is cooling down.
The thermostat dial is continuously adjustable. A higher temperature is set by turning it clockwise; a lower
temperature by turning it anticlockwise.

Safety features

In case of internal overheating, the overheating safeguard will switch the heater off. If this occurs, immediately
turn the mode selector dial to O, unplug and allow heater to cool down for at least 10 minutes. In theory, the
heater can now be used as normal. There is, however, generally a reason for an appliance overheating. This may
be because the heater cannot adequately release its heat or take in fresh air (because the heater is covered, the
grills are blocked, the heater is placed too near a wall etcetera). Before using the heater again, therefore, remove
or adjust whatever caused the appliance to overheat. If you cannot find the cause and overheating recurs, stop
using the heater and contact your vendor or a certified electrician for inspection/repair. Overheating poses a
serious fire risk!

Cleaning and Maintenance

Keep the heater clean. Deposits of dust and dirt in the appliance are a common cause of overheating so these
should be removed regularly. Switch off the heater, remove the plug from the socket and allow the heater to cool
down before cleaning or carrying out maintenance work..

Wipe the outside of the heater regularly with a dry or slightly damp cloth. Do not use aggressive soaps,
sprays, cleaners or abrasives, waxes, polishes or chemical solutions!

Use a vacuum cleaner or compressor to carefully remove any dust and dirt from the grills and ensure that
the air intake and outlet openings are clean. Be careful not to touch or damage any internal parts during
cleaning!

The heater contains no other parts which need maintenance.

At the end of the season, store the cleaned heater in the original packaging if possible. Store upright in a
cool, dry and dust-free place.

Do not dispose of the heater with household waste when it becomes worn or damaged beyond repair. Take
it to your local authority's collection point for electrical appliances where any reusable materials will be
collected and redistributed.

CE-statement

Eurom - Genemuiden-NL hereby declares that the EUROM workspace heaters, type EK2001 complies with the
LVD guideline 2014/35/EU and the EMC guideline 2014/30/EU and meets the following standards:
EN 60335-1:2012+AC :2014+A11 :2014
EN 60335-2-30:2009+A11:2012
EN 62233 :2008
Genemuiden, 27-06-2017
W.J. Bakker, alg. dir.
EN 55014-1:2006/+A1 :2009/+A2 :2011
EN 55014-2:1997/+A1 :2001/+A2 :2008
EN 61000-3-2:2014
EN 61000-3-3 :2013
14