Load Limits; Optional Accessories; Necessary Accessories; Installation And Commissioning - Tractel corso LT-1B Manuel D'installation Et De Manutention Original

Operation and Installation Manual
4.6

Load limits

DANGER!
Incorrect anchoring! Incorrect usage!
Risk of being injured by falling objects!
The load on the deflection roller, rigging and the anchoring
point increases depending on the arrangement of the hoisting
gear, deflection roller and load!
– The support's minimum breaking strength rating must
exceed the hoisting gear's maximum working load by
fourfold for the given installation situation (see Fig. 7).
– If the lifting equipment is attached directly to the anchor-
ing point (see Fig. 7), the deadweight of all of the line
components and the dynamic rate of strain of the hoisting
gear drive system must be taken into account.
Incorrect anchoring! Incorrect usage!
Pulling at an angle is only permitted within the limits specified
Table 1 on page II!
– Please observe the specifications for the angles α and β,
see Table 1 on page II.
5

Optional accessories

The following accessories can also be purchased:
tirak™ motor-driven wire rope hoist

 greifzug™ hand-operated multi-purpose cable hoist
minifor™ motorized cable hoist

 tralift™ TE electrical chain hoist
 bravo™ lever hoist
tralift™ pulley block

 Deflection rollers, adapter
Please directly contact TRACTEL Greifzug GmbH.
6

Necessary accessories

The following accessories, which are not part of scope of deliv-
ery, are necessary to use the product:
Rigging and securing equipment with an adequate minimum

breaking strength (see 'Structural requirements' on Page 5).
Manual or electrical hoisting gear

Other original Greifzug accessories: See '5 Optional accessories'
on page 6.
The operator or the manufacturer of the system is responsible for
selecting and using the accessories in accordance with the local
conditions. You must also abide by any other requirements of the
respectively applicable regulations and standards.
EN-6
7

Installation and commissioning

7.1

Directives and standards

The machine fulfils the following directives and standards:
Machine Directive 2006/42/EC

 EN ISO 12100:2010
Machines for man riding or man riding and material handling

(transport of persons):
EN 1808:2015
The operator or the system manufacturer is responsible for en-
suring that the machine is used within the limits specified in these
instructions. The operator or the system manufacturer must also
observe the directives and standards for the machine in which
the unit will be fitted.
7.2 Checks to be undertaken before
starting installation
Inspecting the installation site
General
– Check if other components obstruct a correct installation.
The installation space must not contain any sharp or edged
components.
– Check to ensure that the deflection roller, the rigging and
the on-site anchoring point all have the necessary minimum
breaking strength, see 'Structural requirements' on page 5.
If hoisting gear is attached directly to the anchoring point
(see Fig. 5) then the dead weight of all line components and
the dynamic proportion of the load from the hoisting gear
drive system must be taken into account.
– Check that the mounting does not cover any nameplates
(see Fig. 6).
Check the components and the accessories
– Check that the components and the accessories are com-
plete (See '3.2 Scope of delivery' on Page 4 and
'4.2 Components / Modules' on Page 5).
– Check for signs of damage.
7.3

Assembly

Requirements
Assembly may only be performed by trained personnel.

 The workplace must have adequate lighting.
Two people are needed to install heavy mounting clamps.

G940.8 - 01/2021