Application Areas; Description; Functional Description; Components / Modules - Tractel corso LT-1B Manuel D'installation Et De Manutention Original

Application areas

The product is suitable for use under the following operating
conditions:
 For permanent or temporary installations
For short-term operation

 Permitted temperature range see Fig. 1.
DANGER!
Danger of severe accidents!
– Use in areas where there is a risk of explosion is prohib-
ited.
– Use in a corrosive environment is prohibited.
– Use in close proximity to open fire or in an extremely hot
environment is prohibited.
Corrosion protection in accordance with order specifications
1)
Structural requirements
General information
The structural equipment to be used for attaching the product
must be designed in compliance with the applicable Directives
and standards (see '7.1 Directives and standards' on page 6).
The application's overall suspended load must be taken into
account regarding the design of the suspended construction.
The overall suspended load is the actual suspended static load,
which is made up of the payload, the load lifting equipment's own
weight, the additional fittings, the wire ropes and the control and
connection cables.
Systems for the transport of persons:
Man riding equipment must be equipped with a fall arrest device,
which secures the load, for example, on a safety rope against
falling.
Nameplate and warning signs / application
restrictions
Replace missing or illegible nameplates and warning signs im-
mediately.
See Fig. 6.
Item Name
1 Nameplate
The necessary information can be obtained from the nameplate.
Directives and standards
Applicable directives and standards: See '7.1 Directives and
standards' on page 6.
G940.8 - 01/2021
Product versions covered in the manual
The product versions described in this manual are listed in Ta-
ble 1 on page II.
4

Description

4.1

Functional description

The mounting clamp is attached to the supports using '' or 'H'
profiles. The clamping jaws on the mounting clamps grip the
flange on the support. The clamping jaws are adjusted to the
flange width of the support using the spindle.
1)
Lifting devices fitted with hooks can be suspended from the
suspension eyes.
4.2

Components / Modules

See Fig. 2.
Item Name
1 Clamping jaw
2 Suspension eye
3 Spindle
a: Spindle shaft
4 Locking screw
4.1 Threaded pin
4.2 Copper disc
Allen-key (no picture)
4.3

Technical Specifications

The technical specifications are listed in Table 1 on page II.
4.4

Anchoring

The mounting clamp is attached to the supports using '' or 'H'
profiles.
– Note the profile size permitted for the respective mounting
clamp, see Table 1 on page II.
– Observe the maximum working load, see Table 1 on page II.
See also '7.3 Assembly' on page 6.
4.5

Safety equipment

Locking screw
For locking the spindle during operation so that the spindle does
not detach without being noticed, causing the mounting clamp to
fall off.
Operation and Installation Manual
EN-5