EUROM Heat-Duct-Pro 3 Manuel D'instructions page 41

Do not use attachments and/or accessories that have not been
23.
recommended or supplied by the manufacturer.
The appliance (incl. cord and plug) may only be opened and/or
24.
repaired by properly authorised and qualified persons.
Only use this heater for its intended purpose and as described in
25.
this instruction manual.
Not abiding by instructions 23, 24 and 25 may lead to damage, fire
and/or personal injuries. A failure to adhere to these rules also
immediately nullifies the guarantee and vendor, importer and/or
manufacturer
consequences!
Description
EUROM Heat-Duct-Pro heaters are 'real space' heaters, with a powerful fan which
disseminates a great deal of air.
Cold air is sucked in at the back, heated, and then blown out as hot air. Because a
relatively large quantity of air is sucked in and blown out, the air expelled by the
heater does not feel particularly hot. As a great deal of air is heated and blown out,
however, the entire space (not just the air around the heater!) is gradually warmed
up.
A hose can be connected to the discharge vent of the Heat-Duct-Pro heaters (max.
5 m) to lead the vented hot air elsewhere. For this reason the heaters have an
extra powerful fan with a large air displacement.
The heater is fitted with a thermostat and overheating protection.
Heat-duct-pro 3 + 9
1. Housing
2. Air vent
3. Heating coil
4. Foot
9. Air inlet
do not take responsibility
5. Grip
6. Thermostat knob
7. Control knob
8. Motor
41
for any of the