EUROM Heat-Duct-Pro 3 Manuel D'instructions page 44

Mount the trolley as shown in the illustration and description.
- First mount the bottom frame (see Figure 1)
- Then mount the weels (see Figure 3)
- Then mount the upper frame (see Figure 5)
Choose a suitable location for the heater, i.e. at least one metre away from any

obstructions, walls or inflammable materials (see also safety instructions).
Always ensure that the heater has sufficient space at the back to suck in air and
at the front, to blow out hot air.
Make sure the heater is always in an upright position on a solid, flat, horizontal

and non-flammable surface.
Make sure the heater is switched off (switch to O position), then plug into a

correctly functioning, properly grounded 230V-50Hz (Heat-Duct-Pro 3) / 400V-
50Hz, 5-Pole (Heat-Duct-Pro 9 + 15) socket.
Set-up and Operation
If the heater is being used for the first time (or if you want to reset the desired
temperature), turn the thermostat dial to the maximum position (clockwise as far
as it goes).
With the mode selector dial, adjust the heater to suit your preferences: fan only,
half power (only Heat-Duct-Pro 9 + 15) or high power.
Once the temperature in the area being heated has reached the right level, slowly
turn the thermostat dial anticlockwise until you hear a soft click; leave the dial in
that position. The heater will automatically maintain the temperature at this level.
It does this by switching the heating elements off and on when the temperature
rises or falls too much.
Note! After the thermostat has switched the heating elements off, the fan will keep
turning. This means that the air is constantly moved, allowing the heater to
accurately detect if the area is cooling down.
44