EUROM Heat-Duct-Pro 3 Manuel D'instructions page 38

Technical data
Type
Supply voltage
Maximum
capacity
Settings
Air flow
Protection class
Electrical cable
Plug
Dimensions
Weight
General safety instructions
Before using the machine, carefully read this entire instruction
1.
manual. Keep this booklet in a safe place for reference.
Before using your new heater, check it, including cord and plug, for
2.
any visible damage. Do not use a damaged heater, but send it back
to your dealer for replacement.
This heater is exclusively intended to heat workspaces such as
3.
workshops, garages and storage spaces. Use the appliance for this
purpose only.
Under the terms and conditions described in this leaflet, the heater
4.
can be used in wet or damp indoor spaces such as bathrooms and
laundry rooms. Do not place the heater in the vicinity ( at least 1
meter removes) of taps, bathtub, shower, pool, fountains or other
sources of moisture. Make sure it cannot fall into water and prevent
water from getting into the heater itself. If, at any time, the heater
does fall into water, unplug it immediately! Do not use a heater that
has a damp interior but have it repaired. Never immerse the heater,
cord or plug in water and never touch it with wet hands.
The supply voltage and utility frequency, specified on the machine,
5.
need to match those of the socket that is used. The electrical
installation needs to be protected by a residual current device
(max. 30 mAmp).
Heat-Duct-Pro
3
V / 220-240~50
Hz
W 3000
W 0-3000
m³/h 389
IP24
H07RN-F
3G1,5mm²
150cm
Schuko
cm 36,5x26,5x37
kg 6,0
Heat-Duct-Pro
9
400-3N~50
9000
0-4500-9000
1227
IP24
H07RN-F
5G1,5mm²
150cm
5 pole – 16A
46x31,5x42
11,7
38
Heat-Duct-Pro
15
400-3N~50
15000
0-7500-15000
1609
IP24
H07RN-F
5G2,5mm²
150cm
5 pole - 32A
71,4x47,6x53,4
27,8