Télécharger Imprimer la page

EUROM Heat-Duct-Pro 3 Manuel D'instructions page 45

Masquer les pouces Voir aussi pour Heat-Duct-Pro 3:

Publicité

Les langues disponibles
  • FR

Les langues disponibles

  • FRANÇAIS, page 47
The thermostat dial is continuously adjustable. A higher temperature is set by
turning it clockwise; a lower temperature by turning it anticlockwise.
Warning: When using for the first time, you might smell smoke. This is normal and
will disappear after a short while. It occurs because some residual oil is left behind
after the manufacturing process and gets heated up.
Aftercooling
The heater is supplied with an aftercooling system. When switching the heater off,
turn the control knob to "off". O. The heater will first ventilate in order to cool down
internally. This can take three or four minutes, depending on the ambient
temperature. Then the heater will switch itself off. Make sure that you then remove
the plug from the socket. With a very high ambient temperature, the heater will
keep on aftercooling. In this case you can only switch it off by removing the plug
from the socket.
Heat discharge hose
A heat discharge hose can be connected to the air vent in order to lead the heat to
another space. To do this, use the special Heat-Duct-Hose: this has the right
degree of heat-resistance and is supplied with a matching clamp. Also for the hose:
ensure that it does not get too near to flammable materials!
Heat-Duct-Pro 3: 5 m x 26 cm, Art.no. 332414
Heat-Duct-Pro 9: 5 m x 29 cm, Art.no. 332421
Heat-Duct-Pro 15: Upon request
Before use, check that the hose and clamp are fitted properly around the vent and
make sure that the hose never makes a bender smaller than 90°.
Safety features
In case of internal overheating, the overheating safeguard will switch the heat
er off. This may occur if the heater cannot give off enough heat or if it cannot draw
in enough fresh air. As mentioned above, this is generally caused by (partially)
covering the heater, obstructing the air intake and/or outlet grills or installing the
heater too close to a wall or something similar. When the heater has cooled down
sufficiently, it will in principle start again automatically, however if you do not
45

Publicité

loading

Ce manuel est également adapté pour:

Heat-duct-pro 9Heat-duct-pro 15332469332483332490