Riding The Motorcycle - Sherco 125 SE/R Manuel Du Propriétaire

Riding the motorcycle

n Cold engine starting
1. Set the gear selector to neutral.
2. Pull the choke.
3. Start the engine by pressing the starter button, without accelerating.
4. Allow the engine to warm up for a few minutes.
5. Push in the choke.
n Hot engine starting
Follow the previous instructions without steps 2-4 and 5.
n Shifting gears
- The positions of the gear selector are shown on ( p.84)
☛
- To find the neutral position, press the selector down into first gear (a resistance will be felt),
then move the selector up slightly.
1. Close the throttle before changing gears.
2. Engage the lowest gear.
3. Partially open the throttle while engaging the clutch.
n Parking
- Stop the engine with the stop button. The Keyless system will automatically switch off the
ignition after 30 seconds of non-use of the bike.
Become familiar with all of the controls and their functions before using the vehicle.
91