Adjusting The Travel Of The Rear Brake Pedal; Checking The Rear Brake Fluid Level; Filling The Rear Brake Reservoir With Brake Fluid - Sherco 125 SE/R Manuel Du Propriétaire

125 SE/R
Brakes (continued)

ADJUSTING THE TRAVEL OF THE REAR BRAKE PEDAL

2
1
3
4

CHECKING THE REAR BRAKE FLUID LEVEL

FILLING THE REAR BRAKE RESERVOIR WITH BRAKE FLUID

1 2
A
126
- Remove the spring
- Loosen the nut and turn the shaft
2
Rear brake pedal travel
Hold the shaft and tighten the nut
3
Nut
2
- Reinstall the spring
Position the motorcycle on a flat surface.
Check the fluid level through the sight glass.
Ensure that the level (between the arrows)
is closest to the up arrow.
If the level is below the MIN mark, top up the
brake fluid according to the instructions below.
Remove the cap
1
Fill with fluid to the mark as shown
Minerva brake fluid DOT 4
- Reinstall the membrane and the cover using
a new O-ring.
1
3
3mm ≥
A
.
2
M6 10Nm
1
MIN
with its membrane
2
A
≥5mm
.