Adjusting The Chain Tension; Adjusting The Lever - Sherco 125 SE/R Manuel Du Propriétaire

125 SE/R
Chassis maintenance (continued)

ADJUSTING THE CHAIN TENSION

4 1
6 5 4

ADJUSTING THE LEVER

B
116
3 2
7
ATTENTION
Improper chain tension can cause mechanical
damage.
Place the motorcycle on a suitable stand.
Loosen nut
1
Loosen the nuts
2
Loosen or tighten the screws
the correct chain tension.
Chain tension
Monitor the symmetry of the two sides
by observing the position of the marks
Tighten the screws
5
Tighten the nut
6
Rear axle nut
Remove the bike from the stand.

NOTE
7
The sliding piece is designed to accommodate
longer chains by turning it 180 degrees.
The position of the lever can be adjusted to meet
the needs of the rider.
- Turn the knob clockwise to move the lever
B
closer to the handlebar.
until you have
3
50mm...53mm
4
M24 100Nm