Sherco 125 SE/R Manuel Du Propriétaire page 87

Fig 6 Adjustable trip distance function
Fig 7 ODO function
Fig 8 ART function
Fig 9 Clock function
Fig 11 Low battery/ Low
battery error function
Low battery/ Low battery error function:
-> When the battery voltage drops to less than 2.40V, the LO battery
warning will turn on.
-> When the internal battery is critically low, the unit will only display
a blinking «LO» icon.
DST and DST2 can be incremented
or decremented by the user
DST set up (screen 1) → Hold the left Button
down for 3seconds → «DST» icon will flash
→ Hold left Button to decrement/ Hold the
right Button to increment → back to screen 1
DST2 set up (screen 2) → Hold the left Button
down for 3seconds → «DST2» icon will flash
→ Hold left Button to decrement/ Hold the
right Button to increment → back to screen 2
ODO function Odometer (screen 3): displays
the total mileage traveled by the vehicle.
The total distance is displayed in the selected
units, km/h (default) or mph (
This information can not be reset to 0.
Beyond 399 999 km (or miles), the counter
goes back to 0.
ART function Accumulated Ride Time (screen 3):
displays the hours of operation of the vehicle.
This information can not be reset to 0.
Until 99h59min → displayed in one minute
increments
After 99h59min up to 9999h → displayed
in one hour increments
If the unit should reach 9999 hours of
accumulated ride time, the display will stop
incrementing, and will remain at that number.
Clock function (screens 1 et 2): displays clock
information
p.88)
☛
87