Adjusting The Chassis; Handlebar Position - Sherco 125 SE/R Manuel Du Propriétaire

125 SE/R

Adjusting the chassis

HANDLEBAR POSITION

A
B
102
The triple clamps have two holes separated
by a distance A.
Distance between holes A
The handlebar clamps are offset by a distance B
Handlebar offset B
The bike comes standard with
the handlebars in the rear most position.
Remove the four screws
the handlebar top clamps and remove
the handlebar.
Remove the two screws
clamps and place them in the desired position.
Handlebar
lower clamp
Replace the handlebars and top clamps.
Replace the four screws
Handlebar clamps
fixing screws
The handlebars can be rotated forward
and rearward in the clamps.
1
2
13mm
4mm
. Remove
1
. Remove the lower
2
M10x35 40Nm Loctite
and tighten evenly.
1
M8x25
243
® ™
24Nm