Operation In "Ventilation" Mode Only; Operation In "Spa" Mode Only; Operation In "Heating" Mode Only - Olimpia splendid Unico Air 20 SF Mode D'emploi Et D'entretien

3.5.6 - Operation in "Ventilation" mode only

• When used in this mode the air conditioner does not perform any action with regard to temperature and
air humidity in the room.
• To activate this mode, press key B4 on the remote control several times until the automatic ventilation
symbol D1 appears on the remote control display.
3.5.7 - Operation in "Spa" mode only (Automatic)
• In this mode, the machine's temperature is automatically regulated according to the room's temperature.
The fan speed is also automatically regulated according to the set temperature (except in dehumidification
mode).
• To activate this mode, press the B4 key on the remote control several times until the D7 symbol appears
on the display.
3.5.8 - Operation in "Heating" mode only (only models fitted with heating pump)
• Using this mode, the appliance heats the room.
This function is only available for the versions with heat pump (HP).
• To activate this mode, press button B4 on the remote control several times until the D2 symbol appears
on the display.
• In this run mode, the required temperature and fan speed can be set. After three minutes (maximum time)
the compressor should start and the air conditioner starts heating the room.
• The start of the compressor is indicated by the lighting up of the LED B (green) located on the console
(fig.37).
The air conditioner has to defrost its battery periodically.
During this operation the air conditioner does not heat the room, though its internal
parts remain on except for the room air fan. when the outdoor temperature is very
low, there may be a slight delay for passage from the minimum to the medium or
maximum speed from when the command is sent to the machine with the remote
control.
Like delays might occur on activating the swinging function of the mobile baffle.
After having turned off the unit, the internal fan runs seconds more. Then it stops
and both air flaps close.
EN - 23
UNICO AIR
INVERTER R32