2.5 - TOP/BOTTOM INSTALLATION CONFIGURATION
The unit can be installed both in the lower part (adjacent to the floor) and in the upper part (adjacent to the
ceiling) of the wall.
Depending on installation (ceiling or floor) it is sufficient to change the electronic configuration so as to opti-
mize the aperture angles of the air outlet flap.
2.5.1 - Electronic configuration for lower or upper wall installations
Work as follows (see fig. B):
a.
Insert the plug in the power socket to power the air conditioner, then
make sure it is switched to stand-by mode.
b. Check that all the LEDs on the display are off;
press and hold down the H button, when an acoustic
signal sounds, release the button.
c. To configure the unit for wall-mounted installation at the
top, press button H, LED C (yellow) will light up.
d. To configure the unit for bottom wall installation, press
button H again, LED D (green) will light up.
e.
Wait a few seconds until the standby mode is restored
and check that all the LEDs on the display are off before
starting the unit.
During the configuration phases point (c) and point (d) the LED D (green) and the LED A (red) will
also light up.
3 - USE
3.1 - WARNINGS
The installation and electrical connection of the air conditioner should be carried out by specialized
personnel who possess the requisites set forth by law.
The installation instructions are contained in the appropriate paragraph of this manual.
No structural object (furniture, curtains, plants, leaves, blinds, etc.) should ever
obstruct the normal flow of air from either the internal or external gratings.
• Never lean or, worse yet, sit on the casing of the air conditioner as this could cause serious
damage to the external parts.
• Do not move the air outlet flap by hand. Always use the remote control to adjust baffle position.
• If the unit leaks water, switch it off immediately and disconnect it from the power mains. Call
the nearest service centre.
• When the air conditioner is heating, it has to periodically eliminate any ice that could form on
the external battery. While it is doing this, the machine keeps running but does not heat the
room. This lasts for a brief period of time, from 3 to a maximum of 10 minutes.
• Clean the air filter periodically, as described in the specific paragraph (4.1.2).
EN - 18
G
LED D
LED B
LED C
LED A
H
37