Electric Hook-Up - Olimpia splendid Unico Air 20 SF Mode D'emploi Et D'entretien

• To make the electrical connection and fasten the drainpipe, place a wedge between the air con-
ditioner and the wall (see fig. 24).
• When you have finished, inspect carefully to make sure there are no fissures at the back of the
air conditioner (the insulating gasket must fit firmly against the wall) particularly in the zone
where air enters and leaves the machine.

2.4.6 - Electric hook-up

The appliance is fitted with a power cord with plug (Y-type connection).
If the socket is in proximity to the appliance, simply plug it in.
Before connecting the conditioner, ensure that:
• The power supply voltage and frequency values comply with those indicated
on the data plate of the appliance.
• The power supply line is fitted with an efficient earth connection that is ap-
propriately sized for the maximum absorption of the conditioner (minimum
cross-section of the cable must be 1.5 mm
• The appliance is powered exclusively through a socket that is compatible with
the plug supplied.
Any replacement of the power cable must be carried out solely by authorized
technical support or by similarly qualified personnel.
On the power supply line of the appliance there must be an adequate omnipolar
disconnection device that complies with the national installation regulations.
It is, however, necessary to check that the electrical power supply is equipped
with efficient earthing and with adequate protections against overloading and/
or short circuits (a type 10 AT delayed fuse or other devices with equivalent
functions are recommended).
To replace the power cord, proceed as follows:
a. Raise the air suction grille (3) and remove the two screws (1a) (fig. 27).
b. Aprire il flap (1) e rimuovere la vite (1b) (fig. 28).
c. Remove the front cover (fig.29).
d. Unscrew the three fixing screws (X2) to remove the front cover of the switchgear (X1) (fig. 30).
e. Remove the electrical panel (X1) (fig. 30).
f. Unscrew cable clipping clamp (J1) (fig. 31).
g. Unscrew the cables locking screws of the terminal board (J2) (fig. 31)
h. Extract the old cable and insert the new one by following the same path.
i. Lock the three poles of the cable in the terminal board (J2) and tighten the screws (fig. 31).
l. Lock the cable with the clamp (J1) (fig. 31).
m. Close the switchgear.
n. Reassemble the front cover of the machine.
o. Tighten the screws (1a) and (1b).
).
2
UNICO AIR
EN - 17
INVERTER R32