Publicité
Les langues disponibles
Les langues disponibles
EN
FIRST POWER-ON
After the machine has been connected to the
waterworks and the electric network, press the
MULTIFUNCTION button
Upon the first power-on, the machine will ask
you to select the language:
English (default setting)
French
Spanish.
Select the language by scrolling arrows
then confirm by pressing
The second screenshot will ask you to select the
water hardness:
0-160 ppm (default setting)
161-250 ppm
251-360 ppm
Select the hardness by scrolling arrows
then confirm by pressing
The third screenshot will ask you to select the
time to be set before entering the Stand-by
mode:
90 minutes
2 hours
4 hours (default setting)
6 hours
Select the time by scrolling arrows
confirm by pressing
8
PREPARING THE MACHINE
to turn it ON.
.
.
then
.
The fourth screenshot will ask you to load the
hydraulic circuit: press
Then the machine will start loading the hydrau-
lic circuit, the display will show the following an-
imation until the cycle is completed.
SYSTEM FILLING
If an error should occur during the hydraulic
charging phase, verify that the tank has
been fitted into place correctly and, also,
that enough water is available, then repeat
the operation.
The machine starts the warm-up cycle.
The MULTIFUNCTION button
with steady white light and the display will show
the following animation.
The machine will be ready for use when the sup-
ply buttons light up to a steady white light.
to confirm.
turns on
Publicité
