LAVAZZA CLASSY PRO DWC Mode D'emploi page 32

EN
N° Problem encountered
Machine does not turn
on.
Power lights are
1 off after having
pressed the
MULTIFUNCTION
button .
The machine requires a
2
lot of time to heat up.
The machine is very
3
noisy.
The machine No
4
supply.
32
TROUBLESHOOTING
Possible causes
1 - Machine is not
connected to the
power source.
2 - The machine is
connect to power
strip not working.
3 - Power supply not
present.
1 - Machine storage at
low temperatures
(e.g.: cellar/
garage).
2 - The machine has
limescale build-up.
1 - Machine not is on
a flat and stable
surface.
2 - Power supply
cable incorrectly
positioned.
3 - Movable parts not
fitted properly.
4 - Capsule not
present.
1 - Electrical failure:
buttons not
working.
2 - No water
3 - Power-on failed.
Solution
Connected the machine
to the power source.
Connected the machine
directly to the power
source.
Connect another device
to check the power
supply.
Store the coffee machine
in a proper environment
and run 2 supplies
without capsules.
Descale the machine.
Check the surface.
Check the correct
position of the cable into
the base of the machine.
Fit the movable parts
properly.
Insert Lavazza capsule or
compatible.
Press one of the buttons
and check the operation
of the pilot light (ON
with white blinking
light) and the machine
power-on.
Check the water
connection.
Repeat the coffee
machine power-on
procedure.
Result
Ok: call solved.
Non-ok: go to step 2
Ok: call solved.
Non-ok: go to step 3
Ok: machine being
serviced.
Non-ok: electric
system fault.
Ok: call solved.
Non-ok: go to step 2
Ok: call solved.
Non-ok: machine
being serviced.
Ok: call solved.
Non-ok: go to step 2
Ok: call solved.
Non-ok: go to step 3
Ok: call solved.
Non-ok: go to step 4
Ok: call solved.
Non-ok: machine
being serviced.
Ok: call solved.
Non-ok: go to step 2
Ok: call solved.
Non-ok: go to step 3
Ok: call solved.
Non-ok: machine
being serviced.