Operation; Connecting The Device; Adjusting The Sution Force - Cleanmaxx XL-306E-220 Mode D'emploi

operation

PLEASE notE!
❐ Never hold the nozzles, the handle or the telescopic tube close to parts of your body. You
could be stuck to the device. Should the vacuum cleaner become stuck, press the on / off
switch immediately to turn off the device.
❐ Turn on the vacuum cleaner only when you have checked that all the parts have been
properly attached and that the dust container and both filters are correctly installed.
❐ Do not pull out the cable with force up to its maximum length. It should not be pulled out
further than the red mark. The yellow mark indicates the optimum lead length.
❐ On no account should the device be used to pick up the following:
– Liquids or wet substances (e. g. wet carpet shampoo)
– Glowing ash, cigarette ends, matches, etc.
– Inflammable or explosive substances
– Very fine dust (e. g. concrete dust) or toner
– Pointed, hard substances such as e. g. large pieces of broken glass

connecting the device

1. Pull out the mains lead as far as required for cleaning.
2. Insert the mains plug into a plug socket.

Adjusting the sution force

The suction force can be steplessly regulated as the adjusting wheel.
08190_DE-GB-FR-NL_V3.indb 24
All manuals and user guides at all-guides.com
3. Press the on / off switch to turn on the vacuum cleaner. The vacuum
cleaner can be pulled along like a sledge during cleaning.
4. Guide the nozzle over the surface to be cleaned.
• Turn it in direction max to increase the suction force.
• Turn it in direction min to reduce the suction force.
24
20.11.12 15:17