Numatic TTV 5565 Mode D'emploi Utilisateur page 28

!
Always ensure that chemical manufacturer's safety guidelines are followed.
Chemical dosing System
The TTV 5565 scrubber dryer has an optional automatic chemical-dosing system.
Simply fill the 5 litre chemical dosing bottle and the machine will deliver the correct mix ratio as set by the operator,
depending on the floor and cleaning conditions.
24
To fill the chemical-dosing bottle, first make sure the top waste-water tank is fully drained then, lift up the waste-water
tank (Fig.24), remove the dosing bottle, unscrew the bottle cap and fill with appropriate cleaning chemical, or fit your own
chemical container, reusing the original Numatic container cap 38mm or 42mm (Fig 25).
Refit dosing bottle and replace bottle cap, and carefully lower waste-water tank.
After use, ensure the chemical dosing tank is emptied, cleaned and refilled with clean-water.
The dosing pipes also need to be cleaned and flushed through with clean-water for at least 60 seconds after use.
!
Do not operate machine unless the Operator Manual has been read and fully understood.
The machine is now ready to be moved to the cleaning site.
Before performing the cleaning operation, place out appropriate warning signs and sweep or dust-mop the floor.
WHEN HANDLING AND MIXING CHEMICALS
Only use chemicals recommended for use in auto scrubber-dryers.
Note: always ensure that the waste-water tank is empty before lifting.
IMPORTANT
28
25
!
!