Numatic TTV 5565 Mode D'emploi Utilisateur page 26

Filling the Clean-water Tank
The TTV 5565 is equipped with a large capacity 85 litre clean-water tank allowing, for large areas to be covered
in a single fill.
20
To fill the clean-water tank, extend the hose located to the rear of the machine in the centre of the removable filler cap,
see (Fig.18). Pull out hose (Fig.19). Open the stopper (Fig.20) and place hose under water tap, or use a hose to
commence filling (Fig.21).
Or the tank can be filled by unscrewing the filler cap and using a bucket or similar container (Fig.22).
Note: Great care must be taken to ensure that contaminants (leaves, hair, dirt, etc.) are not allowed to enter the
clean-water tank during the filling process. If using a bucket or similar, ensure it is always clean and free from debris.
23
Machine Set-Up
18
21
Fill-level Indicator
The water level in the clean-water tank can be measured using the
scale on the rear of the machine (Fig.23).
The clean-water bottom tank holds 85 litres.
19
26
22