Putting The Machine Into Service; Instructions For Use - Grillo G84 Manuel D'emploi Et D'entretien

Wheels: 4.00-8, 4.00-10, 5,00-10
Tiller: standard at 58 cm and adjustable at 37-47-68
Handlebar: height and side adjustable, reversible
External dimensions: 42 – 37 cm with 4.00-8 wheels – 36 – 44 cm with cage wheels
Attachments: rotary tiller, cutting bar, snow thrower, plough, furrower, flail moer, towed trailer, all
purpose flail, transport wheel for tiller, wheel weights, cage wheels, sweeper, snow blade.
1) Check that the machine has not been damaged during transport.
2) Remove the walking tractor from the package, paying attention not to damage wires and levers.
Use a lifting machine (min. capacity: 200 kg). Before putting the machine on the ground mount the
wheels and make sure the nuts are well tightened (fig. 3, n. 8).
3) The walking tractor is delivered with the handlebar positioned over the engine (sickle-bar
version). To turn the handlebar to use the rotary tiller push the lever (fig. 3A, n. 12) and slowly turn
the handlebar 180° in anti-clockwise direction, paying attention not to force this mechanism and
not to damage wires. Then insert the control levers
4) Before connecting the implement, the PTO coupling of the machine has to be filled with grease.
Then mount the implement(e.g. tiller, plough...) and make sure the nuts are well tightened (fig. 4A,
n. 20).
5) Add engine oil (see the engine manual).
6) Add gearbox oil – fig. 6 (MP 80W90 oil, or international equivalent API GL5 oil, US MIL-L-
2105D)
7) Add oil into the air filter in oil bath (for versions provided with this type of filter), use the same oil
type as the engine oil (fig. 7A).
8) Check the tyre pressure according to the table below:
4.00-8
4.00-10
5.00-10
Before starting the engine always check:

the oil levels inside the engine (fig. 5, ref. A) and the gearbox; the level check cap is on the
upper cover (fig. 6); the oil level must be between the two notches.

that all screws and nuts are well tightened especially those fastening the attachments to the
machine (fig. 4A).

that all levers are in neutral.

that the air filter (dry version) is clean (fig. 7). Caution! Never blow the cartridge with
compressed air; if clogged it must be replaced.
clean and that the oil is at the right level (fig. 7).

that the air filter (in oil bath version) is clean and its oil at the right level (fig. 7A).

check the oil level inside the tiller gearbox (fig. 4D no. 3)

fill the tank with fuel, using a funnel with very fine filter.
STARTING THE PETROL ENGINE
Turn on the petrol cock (fig. 4B, no. 21) push the throttle lever (fig. 3 n. 14) to the midway position
and, if the engine is cold, engage the choke on the carburettor (fig. 4B, no. 18). Start the engine by
pulling hard on the pull starter handle (fig. 4B, no. 6).
Translation of the Original Instructions

PUTTING THE MACHINE INTO SERVICE

TYRE PRESSURE
2 PLY RATING
2 "
2 "

INSTRUCTIONS FOR USE

"
"
Check that the air filter (oil bath version) is
8
1,1 BAR
1,1 "
1,5 "