Grillo G84 Manuel D'emploi Et D'entretien page 19

Translation of the Original Instructions
ADJUSTABLE WHEEL SPACERS
These innovative screw spacers are advisable above all for ploughing. If you have to change the
track gauge, please unlock the two keys kept by the springs, start the machine, put the first gear,
block the differential lock and release the clutch when the engine is at minimum; in this way the
track gauge is automatically changed. Attention not to unscrew them completely. Position the keys
and respective springs again. Now you can change the track gauge, lifting the machine and
operating manually (fig.25).
BACK-CUTTER FURROWER
This tool is mounted at the rear of the tiller and works in tandem with it. The furrower is designed to
produce irrigation and seed drills (fig. 26). For the coupling mount the bushing (fig. 9).
CAUTION: Keep your hands and feet away from the rotary tiller hood when the engine is
running, rotation of the tiller is highly dangerous. Before connecting or removing the
support wheel, ALWAYS SWITCH OFF THE ENGINE.
TILTING FRONT BLADE – 125 cm
This highly resistant device is ideal for removing snow and levelling mounds of soil or gravel. It can
be be tilted to the right and left (fig. 27).The front blade has to be connected to the implement
flange using the quick coupling. The handlebar must be turned through 180towards the engine (to
carry out this procedure follow the instructions outlined above for the cutting bar)
PIVOTING BRUSH – 100 cm
This brush (fig. 28) can be attached to the machine following the mower bar's instructions. It is very
useful to clean roads and squares. It can also be used to clean up 10-12 cm high fresh snow and it
can be steered left or right to make drifts. It can be be tilted to the right and left. The handlebar
must be turned through 180towards the engine (to carry out this procedure follow the instructions
outlined above for the cutting bar). To engage the brush the safety system preventing the reverse
gear and the PTO from being engaged at the same time (which is then necessary with the rotary
tiller) has to be deactivated. The operator has to remove the screw (fig. 2). Important: if the
rotary tiller is connected again, the safety system has to be brought back to its original
working condition. Grillo bears no responsibility in case of non-compliance with this rule
(fig. 2 – fig. 2A).
WARNINGS FOR TRANSPORT
Walking tractors cannot be used on public roads. If the machine is to be transported on a lorry or a
trailer, lower the handlebar, engage the 1 st gear, fasten the walking tractor to the lorry/trailer using
ropes or belts. If a lifting machine is used to lift the walking tractor from the ground into the
lorry/trailer make sure its lifting capacity its suitable for the walking tractor.
16