Starting Work; Putting The Machine Into Service; Instructions For Use - Grillo PRINCESS M1-MR Manuel D'utilisation

Table des Matières

Publicité

Les langues disponibles
  • FR

Les langues disponibles

  • FRANÇAIS, page 17
FINAL DRIVE: with pinion and chain.
CLUTCH: with lever control on the handlebar working on belt tensioner.
HANDLEBAR: with height and side adjustment.
ROTARY TILLER CASING: bolted and in pressed steel.
STANDARD ROTARY TILLER: with six tines and side discs for a total width of 800mm – MP3
PRO: 27 mm hexagonal shaft with six tines and side discs for a total width of 970 mm.
TINES DIAMETER: 320 mm – MP3 PRO 330 mm
WORKING AREA without side discs: adjustable at 300 – 520- 770 mm – MP3 PRO adjustable
at 560 – 820 mm.
WORKING AREA DEPTH: 320 mm – MP3 PRO 330 mm
TILLER RPM: I° gear 36 r.p.m.- II° gear 160 r.p.m. – reverse gear 36 r.p.m.
SAFETY DEVICES: the machine stops automatically when user releases the handlebars; guards,
handlebars complying with current law; silencer-protection.
STANDARD FEATURE: front transfer wheel.
ATTACHMENTS: furrower, plough kit, transfer wheels for rotary tiller Ø 42X4 cm.
-
Check that the machine has not been damaged during transport.
-
Fix the two tiller elements (fig.5).
-
Fit the transfer wheel (fig. 1 – fig. 2 – fig.3, no. 6) using the spring.
-
Fix the spur (fig.1 – fig. 2 – fig. 3, no. 3)
-
Fit the fenders (fig. 1, no. 12 – fig. 2 – fig. 3, no. 13).
-
Fill the engine oil up to level (always refer to the engine manual).
BEFORE STARTING THE ENGINE
- fill the tank with fuel.
- check that the air filter is clean.
- check the engine oil level.
STARTING THE ENGINE
- Set the throttle lever in STARTER position. If the engine is cold, turn the starter lever to CHOKE
(always refer to the engine manual).
- Start the engine by pulling the pull-start handle (fig.1 no.6).
- Once the engine is running return the starter lever to RUN and the throttle lever almost to the
minimum setting.

STARTING WORK

- Adjust the height and lateral position of the handlebar to get the best working position using the
knob (fig. 1 – fig. 2 – fig. 3, n. 2)
- Adjust the working depth by lowering or raising the rear foot (fig. 1 – fig. 2 – fig. 3, no. 3)
- Pull the transfer wheel support down and raise to showed position (fig. 1 – fig. 2 – fig. 3, no. 7).
- Speed up the engine (fig. 1 – fig. 2 – fig. 3, no. 1)
- Slowly press the forward lever (fig. 1 – fig. 2 – fig. 3, no. 1) until the machine starts moving.
In the MR model pull the RM lever to engage the reverse gear. Safety device: if this lever is
released even accidentally, the machine stops.
All manuals and user guides at all-guides.com
Princess9/ Translation of the original instructions

PUTTING THE MACHINE INTO SERVICE

INSTRUCTIONS FOR USE

7

Publicité

Table des Matières
loading

Ce manuel est également adapté pour:

Princess mp3-pro

Table des Matières