Britax Roundabout 55 Guide D'utilisation page 20

Child Seat Functions
Tether anchor locations vary from vehicle to
vehicle. Check your vehicle owner's manual
and look for the tether anchor symbol shown
in the diagram to help identify where the
top tether anchor points are located in your
vehicle. Britax recommends that the tether be
used at all times when installing the child seat.
Using the tether will improve the stability of
your child seat and reduce the risk of injury.
See the diagrams below for possible rear-
and forward-facing Versa-Tether installation
configurations.
Tether Configurations
OR
Rear-Facing
Rear-Facing Tether Connector Strap
Because every vehicle model is different, a location to
anchor the tether for rear-facing installations may vary.
Use the rear-facing tether connector strap to assist in
creating an anchor point.
1 Find a fixed location in the vehicle that is bolted
to the floor.
* If you cannot find a location to create an
anchor point, contact the vehicle manufacturer
to identify a tether connection point.
2 Route the strap through the anchor point.
3 Thread the metal D-ring through the
loop on the end of the strap.
4 Pull the metal D-ring through until
the strap is tight.
5 Use the D-ring as an attachment
point for the tether.
NOTE: Store the tether connector strap in
the tether pouch when not in use.
Attaching the Versa-Tether
IMPORTANT: The Versa-Tether
use when you wish to carry the child seat between
locations. Do not install the child seat with the Versa-
Tether attached to the carry clip. Secure the excess
Versa-Tether webbing in the elastic strap during use.
Store the Versa-Tether in the storage pouch when not in
use. Always ensure any excess webbing is contained
within your vehicle.
18
Rear-Facing
®
carry clip is only for
OR
Forward-Facing
3
5