Britax Roundabout 55 Guide D'utilisation page 33

1 Loosen the harness.
a Lift harness adjuster lever
b Pull both harness straps forward
2 Remove the body pillow and
unbuckle the harness.
3 Lift the back cover, then pull the
seat cover forward to access the
forward-facing belt path.
4 Route the vehicle seat belt
through the forward-facing belt
slots, then buckle. Ensure the
vehicle belt is not twisted.
5 Push down on the middle of the
the child seat while pulling the
vehicle belt to remove all slack
(see pages 7 and 8).
6 Attach the Versa-Tether to a
designated anchor (see vehicle
owner's manual) and remove slack
(see pages 17 – 19).
7 Store the excess webbing in the
elastic strap.
8 Replace the cover.
Checklist
Check that the vehicle belt is securely fastened.
Check that no more than 20% or 7.6 cm (3 inches) of the base hangs
over the edge of the vehicle seat.
Check that the child seat cannot be moved front to back or side to side
more than 2.5 cm (1 in.) at the belt path. If the child seat is not secure,
repeat installation or use a different seating location.
Check that any excess Versa-Tether
vehicle and secured in the elastic strap.
Forward-Facing Installation
1b
1a
®
webbing is contained within your
4
5
31