Connect The Product; Set-Up Your Product; Manual Network Configuration - Gorgy Timing LEDI Mode D'emploi

1.1.2. Connect the product

It is highly recommended that you notice the serial number (written on identification

stamp), the localization and a short description for the product. The table in You can
use the table in Appendix F – Additional documents

Connect the synchronization outputs to your equipment (see Appendix A – Connec-
tions for more information).

Connect the LEDI Network ITS/DCLS/NTP Server to your network using the network cable.

Connect the LEDI Network ITS/DCLS/NTP Server to a power supply using the
power supply cable when it is present.
Your system should work immediately if there is a DHCP server on your network.
However, Gorgy Timing recommends you to fill-in for each product its physical locali-
zation. This is possible using the GTNetMng tool localized on the CD-ROM. For more
information, see part 1.2.

1.2. SET-UP YOUR PRODUCT

1.2.1. Manual network configuration

Gorgy Timing NTP products are configured in factory to automatically get an IP ad-
dress. Two mechanisms are used:
► If a DHCP server is present on your network, our products get an address automa-
tically. This ensures that the IP address is compatible with your network.
► If no DHCP server is present, the product automatically takes an IP address using
the AutoIP mechanism. In this case, the address is in the range 169.254.x.y (where
x and y are in the 0..255 range). If both server and client have started in this mode,
they should work correctly together but their IP addresses may be incompatible with
other devices on the network.
If you don't have a DHCP server or you want to configure yourself the network parameters,
use the GTNetMng tool on the CDROM to change the network parameter. Please refer to
part 1.2 for more information.
☛
Don't hesitate to contact your network administrator for the configuration
of the device. He can help you to optimize your network installation
1/ For example, you may not have the possibility to configure the LEDI Network ITS/DCLS from a WEB navigator.
MDE-LEDInetworkITS-server-4078V1.3
1
1. INTRODUCTION
71