What To Do If - Progress PBN1320 Notice D'utilisation

30 progress
Installing the door and the glass panel

WHAT TO DO IF...

Warning! Refer to "Safety information"
chapter.
Problem
The appliance does not oper-
ate.
The appliance does not oper-
ate.
The oven lamp does not oper-
ate.
Steam and condensation col-
lect on the food and in the
oven.
If you cannot find a solution to the problem
yourself, contact your dealer or the service
centre.
We recommend that you write the data here:
Model (MOD.)
Product number (PNC)
Serial number (S.N.)
2
1
Possible cause
The appliance is not activated.
The fuse in the fuse box is re-
leased.
The oven lamp is defective.
You left the dish in the oven for
too long.
7. Carefully lift (step 1) and remove (step
2) the glass panel.
8. Clean the glass panel with water and
soap. Dry the glass panel carefully.
When the cleaning is completed, install the
glass panel and the oven door. Do the
above steps in the opposite sequence.
The screen-printing zone must face the in-
ner side of the door. Make sure that after
the installation the surface of the glass pan-
el frame on the screen-printing zones is not
rough when you touch it.
Make sure that you install the internal glass
panel in the seats correctly. Refer to the il-
lustration.
Activate the appliance. Refer to
the chapter "Daily Use".
Do a check of the fuse. If the
fuse is released more than one
time, contact a qualified electri-
cian.
Replace the oven lamp.
Do not keep the dishes in the
oven for longer than 15 - 20
minutes after the cooking ends.
The necessary data for the service centre is
on the rating plate. The rating plate is on
the front frame of the appliance cavity.
.........................................
.........................................
.........................................
Remedy