What To Do If - Progress PBP5360 Notice D'utilisation

Installing the door and the glass panel

WHAT TO DO IF...

Warning! Refer to "Safety information"
chapter.
Problem
The oven does not heat up.
The oven does not heat up.
The oven does not heat up.
The oven does not heat up.
The oven does not heat up.
The oven does not heat up.
The oven lamp does not op-
erate.
The oven does not heat up.
The fan does not operate.
The display shows
.
The display shows an error
code that is not on this list.
Possible cause
The appliance is deactivated.
The clock is not set.
The necessary settings are not
set.
The automatic switch-off is on.
The Child Lock is on.
The fuse in the fuse box is re-
leased.
The oven lamp is defective.
The demo mode is activated.
or
There is an electronic fault.
When the cleaning is completed, install the
glass panels and the oven door. Do the
above steps in the opposite sequence.
Make sure that you put the glass panels
back in the correct sequence. The second
panel has a decorative frame. The screen-
printing zone must face the inner side of
the door. Make sure that after the installa-
tion the surface of the glass panel frame on
the screen-printing zones is not rough
when you touch it.
Make sure that you install the middle panel
of glass in the seats correctly (refer to the il-
lustration).
Activate the appliance.
Set the clock.
Make sure that the settings are
correct.
Refer to "Automatic switch-off".
Refer to "Deactivating the Child
Lock".
Do a check of the fuse. If the fuse
is released more than one time,
contact a qualified electrician.
Replace the oven lamp.
1. Deactivate the appliance.
2. Press and hold the button
for approximately two sec-
onds. An acoustic signal
sounds.
3. Press and hold the buttons
and
the acoustic signal sounds
again and the indicator goes
out.
1. Deactivate the appliance with
the house fuse or the safety
switch in the fuse box and acti-
vate it again.
2. If the display shows the error
code again, contact the serv-
ice centre.
progress 39
Remedy
at the same time until