Viscount
UNICO P
9. INSTRUMENT GENERAL SETTINGS
The SET-UP menu contains all the instrument's general settings except for the settings relating to the MIDI
interface and the accessory and utility functions. To recall this menu, select the SET-UP field from the main
video page:
The functions available are as follows:
o TREMULANT: setting of the tremulant speed and depth for each individual manual.
o REVERBERATION: selection of the type of room for the reverb effect.
o INT. AMPL. EQUALIZER (Internal amplification equalizer): setting of the 5-band equalizer of the
internal amplifier.
o INT. AMPL. PANNING (Internal amplification panning): setting of the stereophonic distribution of
the stops of the internal amplification system, to simulate different types of wind- chests for the various
stops.
o PROG. FUNCTION (Programmable functions): settings relating to operation of the combinations,
the pistons, the Crescendo and the trimmers underneath the manuals.
o EXT. OUT EQUALIZER (External outputs equalizer): setting of the equalizers of the PROG. OUT
outputs on the rear.
o EXT. SUB EQUALIZER (External sub equalizer): equalizer adjustment for the external output on the
back [GEN. SUB.].
o EXT. OUT ROUTER (External outputs router): setting of the routing of the stops on the PROG.
OUT outputs on the rear to simulate the position of the wind-chests and the arrangement of the pipes
inside them.
o EXT. OUT VOLUME (External outputs volume): setting of the volumes of the PROG. OUT outputs
on the rear.
o EXT. OUT CONFIG (External outputs config): setting of the PROG. OUT rear outputs.
o EXT. OUT RESIZE (External out resize): Adapts automatically the link between stops and rear
outputs, according to the amount of outputs actually used.
9.1 SETTING THE ROUTING OF THE VOICES ON THE REAR AUDIO
OUTPUTS (EXT. OUT ROUTER function)
One of the Unico series organs' key features is the capability for simulating the position of the wind-chests
and the arrangement of the pipes inside them, for every stop. This is achieved by setting the routing of the
audio signals, i.e. the way in which they are distributed, on the rear outputs.
For each stop, the system is able to set an output configuration which reflects the layout of the pipes in real
wind-chests, as follows:
- single or double cusp
- double wing
35
(SET-UP menu)
48
User Guide