User Guide
remote MIDI unit.
-
MIDI [OUT]: the MIDI connector that transmits the MIDI data generated by the organ.
-
MIDI [THRU]: retransmits the data received by the [IN] port for connection of several MIDI devices
in series.
-
[USB]: two USB connectors. The one on the left is used for connecting to a computer to allow the
instrument's setup programme to be used. The one on the right is for use of an USB stick (not
supplied with the instrument) for use as a mass memory for the organ instead of the internal memory.
For further information refer to chap. 11.
-
[PHONES]: the socket for connecting a headphone set.
11. Switch which enables the power supply on the [EXT. +12V DC] socket.
This socket is located in the back panel (see point 15).
12. Pipe lights potentiometer.
13. Swell expression pedals.
The model P35 feature two expression pedals, one used to control the volume of the Manual I and
Pedalbord, the other to control the Manual II.
14. Coupler toe-studs.
These pistons duplicate the functions of the draw-stop.
15. Rear connections.
On the back of the organ, there are various connections for making the audio connection to external
speaker systems, and the line and microphone input for use of the organ's internal amplifier.
-
[EXT. +12V DC] connectors: +12 Volt can be obtained from these connectors to switch-on any
VISCOUNT speaker connected to the PROG. OUT. outputs.
-
OUT [GEN. SUB] (General Sub-Woofer): dedicated output for the connection of low-frequency
speakers (sub-woofer).
-
PROG. OUT (Programmable Outputs): the instrument's general line outputs, allowing simulation of
the wind-chests of pipe organs. The signals are distributed over the outputs on the basis of the
display function settings, which allow setting of the type of wind-chest, its size and the position in
space of the speakers used, for each stop. Each output also has dedicated level and equalisation
controls.
-
INPUT [L(+R)] / [R]: line inputs which allow other instruments to be played using the organ's
internal amplification. If the source is monophonic use the [L+(R)] connector only.
-
INPUT [MIC]: microphone input allowing amplification of the signal from a microphone.
-
[GAIN]: trimmer for regulating the gain of the input signal received at the [MIC] connector.
WARNING!
This group of connections on the rear is not visible from the outside and the organ's wooden rear
panel has to be removed to access it. Contact qualified staff for this procedure.
39
Viscount
UNICO P
35