Instrument General Settings (Set-Up Menu) - Viscount UNICO 500 Guide De L'utilisateur

Viscount
UNICO 500 - 400 - 300
9. INSTRUMENT GENERAL SETTINGS
The SET-UP menu contains all the instrument's general settings except for the settings relating to the MIDI
interface and the accessory and utility functions. To recall this menu, select the SET-UP field from the main
video page:
The functions available are as follows:
o 1st TREMULANT: setting of the first tremulant speed and depth for each individual manual.
o 2nd TREMULANT: setting of the second tremulant speed and depth for each individual manual.
o REVERBERATION: selection of the type of room for the reverb effect.
o INT. AMPL. EQUALIZER (Internal amplification equalizer): setting of the 5-band equalizer of the
internal amplifier.
o INT. AMPL. PANNING (Internal amplification panning): setting of the stereophonic distribution of
the stops of the internal amplification system, to simulate different types of wind- chests for the various
stops.
o INT. AMPL. TUNE-UP (Internal amplification tune-up): function not available in these models.
o PROG. FUNCTIONS (Programmable functions): settings relating to operation of the combinations,
the pistons, the Crescendo and the trimmers underneath the manuals.
o ENC. CONFIGURATION (Enclosed configuration): program the [ENC] piston function
o EXT. OUT EQUALIZER (External outputs equalizer): setting of the equalizers of the PROG. OUT
outputs on the rear.
o EXT. SUB EQUALIZER (External sub equalizer): equalizer adjustment for the external output on the
back [GEN. SUB.].
o EXT. OUT ROUTER (External outputs router): setting of the routing of the stops on the PROG.
OUT outputs on the rear to simulate the position of the wind-chests and the arrangement of the pipes
inside them.
o EXT. OUT VOLUME (External outputs volume): setting of the volumes of the PROG. OUT outputs
on the rear.
o EXT. OUT CONFIG (External outputs config): setting of the PROG. OUT rear outputs.
o EXT. OUT RESIZE (External out resize): Adapts automatically the link between stops and rear outputs,
according to the amount of outputs actually used.
(SET-UP menu)
56
User Guide
.