Publicité
Les langues disponibles
Les langues disponibles
Viscount
UNICO P
the [MEM. BANK +] and [MEM. BANK -] pistons (point 9).
5. Control and programming section.
Contains the buttons and display for viewing and programming all the instrument's setup and sequencer
functions.
6. Instrument on/off switch.
7. [S] Piston.
Fixing piston for saving the general combinations and the Tutti,
To set a combination or the Tutti, after setting the voices as required, press [S], hold it down and then
press the piston of the combinations you wish to save.
NOTE
If the LED of the [S] piston is off, programming of the organ is locked out by the Lock Organ
function (chapt. 10), so it will not be possible to save combinations and/or view internal programming
functions.
8. General pistons.
These pistons recall the general combinations of the memory bank selected using [MEM. BANK +] and
[MEM. BANK -] (point 9). These combinations can be modified; the procedure for saving them is
described in point 7.
[HR] restores the voice setup prepared in manual mode before a memory was recalled.
General combination sequencer controls are also provided, [PREV] in descending order, [NEXT.] in
ascending order.
9. Organ general controls.
These controls do not refer to individual sections but to the entire instrument.
-
[MEM. BANK +] and [MEM BANK -]: they select the memory bank displayed by the additional
[MEM. BANK] display (point 4).
-
[ENC]: enables the Enclosed function, which allows the organ's general volume to be controlled
using the swell pedal [MAN.II].
-
[A.P.]: enables the Automatic Pedal which allows the pedal voices to be played on Man.I.In this case,
the organ's pedal board is deactivated and the voices become monophonic, with priority to the lowest
note.
-
[T]: piston and foot piston for recalling the Tutti. The Tutti can be modified; the procedure for saving
it is described in point 7.
-
[C]: Cancel piston
NOTE
Memory bank n. 1 is always selected when the instrument is switched on.
10. Front connections panel.
This panel, on the left underneath the manuals, contains the connectors and settings most often used, for
convenient access.
-
[MASTER VOLUME]: regulates the organ's general volume.
-
[REVERB VOLUME]: regulates the level of the reverb effect.
-
MIDI [IN]: the MIDI input connector for allowing the organ to receive the data transmitted by a
35
38
User Guide
Publicité
Chapitres
