Fitting And Removing The Fl Ange; Removing The Fl Ange; Fitting The Passenger Vehicle Fl Ange; Fitting The Commercial Vehicle Fl Ange - Bosch WBE 5210 Notice Originale

en 32 | WBE 5210 | Fitting and removing the fl ange
5. Fitting and removing the
flange
Fitting of the flange is necessary in the following
situations:
+
Commissioning
+
When changing the type of flange
(centering flange, universal flange, special flange)
+
When changing the type of wheel
(passenger car - truck)
!
Balancing accuracy will be impaired if the flange has
not been properly fitted to the shaft.Before fitting the
flange, clean and degrease (remove corrosion protec-
tion) the cone of the shaft and the flange opening.
5.1 Removing the flange
1. Slacken off the hexagon socket head bolt.
2. Unfasten the flange by tapping with a rubber-headed
hammer on the cone end.
3. Pull the flange off the cone.
"
Flange detached.
|
1 695 654 697 2010-11-19
5.2 Fitting the passenger vehicle flange
i
Clean and degrease the cone of the shaft and the
flange opening.
1. Slide the flange onto the shaft.
2. Tighten the hexagon socket head bolt.
"
Flange fitted.
5.3 Fitting the commercial vehicle flange
1. Use 2 bolts to attach the truck spacer ring to the
passenger vehicle flange.
2. Secure the commercial vehicle flange with 2 bolts.
Robert Bosch GmbH